zebranax.blogg.se

that output is what would enable your analog buffer.

This would watch the analog signal going into the module and pulse it's output when it changes. If not, you can try more advanced things like gating that analog buffer you just made with a "Serial/Analog One-Shot" (in the crestron logic symbols under Serial).

An analog buffer in between the module input and the signal may do that. Try disabling that.įailing a solution to stop that from happening, in the crestron code you simply need to prevent the Simpl+ from detecting a change event when the feedback rolls in with the same value as the value already has. However, simulate feedback may cause that to occur. Do you have simulate feedback enabled on the slider? when the value is being set from crestron the slider shouldn't re-propegate that as control to crestron.